Jackery Explorer 1000 v2: Runtime & Specs
By Hicham M. · Specs from Jackery's published documents, as of September 2026 · How we calculate
The Jackery Explorer 1000 v2 is a 1,070 Wh LiFePO4 power station with 1,500 W of continuous AC output and a 3,000 W surge rating. It runs a typical full-size fridge for about 16 hours.
We may earn a commission if you buy through these links. It never changes our numbers, and every model in our database is included whether or not it pays us. Learn more.
Simulated runtimes (not measured)
Nobody tested this unit for this page. These figures come from a computer simulation of the Explorer 1000 v2, and they are estimates. The plain runtime table below divides energy by average draw at 85% efficiency. The simulation also charges the battery for the power the inverter burns just by being switched on, which is why small loads come out shorter. Where we have measured a unit, the measurement is shown separately and labeled as measured.
| Device | Spec-sheet math | Simulated, typical | Likely range | Simulated at 0 °C |
|---|---|---|---|---|
| Wi-Fi router + modem | 2.5 days | 29 hours | 25 hours to 37 hours | 25 hours |
| CPAP (no humidifier) | 30 hours | 20 hours | 18 hours to 24 hours | 18 hours |
| Starlink Standard | 10 hours | 9 hours | 8.5 hours to 9.5 hours | 7.6 hours |
| Refrigerator (full-size, ENERGY STAR) | 16 hours | 13 hours | 12 hours to 14 hours | 11 hours |
Nonstop runtime from full to battery cutoff. Likely range = middle 80% of 200 simulated runs with the uncertain inputs varied. The inverter idle draw is assumed, not published: we assumed about 17 W for this model, varied from 10 to 26 W. If the real figure is lower, real runtimes land closer to the spec-sheet column.
How this was simulated
- The battery is stepped down every 2 minutes until it reaches cutoff, for 200 runs per device. Results are seeded, so the page shows the same numbers on every build.
- Battery draw = load + inverter idle draw + 4–8% of the load + a loss that rises with load squared (4% at full output).
- Usable capacity = 92–98% of rated Wh, for protection cutoff and aging.
- At 0 °C, 80–90% of that capacity is assumed available.
- Fridges cycle on and off every 30–50 minutes at the share of the time set by their average draw. The inverter idle draw continues while the compressor is off.
- Devices that exceed this model's output or surge rating are left out. Loads are US 120 V devices.
These ranges are assumptions about a typical unit. They are not manufacturer figures for the Jackery Explorer 1000 v2. How we calculate · How we use AI
How long will the Explorer 1000 v2 run your appliances?
Nonstop runtime for one device at a time, using typical US wattages and 85% inverter efficiency. Devices marked ✕ can't run on this model.
| Device | Avg draw | Runtime | Bar |
|---|---|---|---|
| LED light bulb | 9 W | 4.2 days | |
| Phone charging | 10 W | 4 days | |
| Wi-Fi router + modem | 15 W | 2.5 days | |
| Laptop | 50 W | 18 hours | |
| CPAP (no humidifier) | 30 W | 30 hours | |
| CPAP with heated humidifier | 60 W | 15 hours | |
| Starlink Standard | 90 W | 10 hours | |
| TV | 100 W | 9.1 hours | |
| Mini fridge | 29 W | 31 hours | |
| Refrigerator | 58 W | 16 hours | |
| Chest freezer | 29 W | 31 hours | |
| Sump pump (1/3 HP) | 160 W | 5.7 hours | |
| Sump pump (1/2 HP) | 210 W | 4.3 hours | |
| Window AC | 225 W | 4 hours | |
| Drip coffee maker | 1,000 W | 55 min | |
| Microwave | 1,500 W | 36 min | |
| Space heater | 750 W | 1.2 hours | |
| Well pump | 33 W | Needs 240 V |
Fridges, freezers, pumps and AC units cycle on and off, so we use their average draw. Want a mix of devices on a schedule? Use the runtime calculator.
The Explorer 1000 v2 in action
Jackery's own video, so expect a sales pitch. It loads from YouTube only when you press play.
Play the Jackery Explorer 1000 v2 video: Stronger. Faster. Smaller. | Jackery Solar Generator 1000 v2
What the Explorer 1000 v2 can't power
- Well pump (1/2 HP submersible): needs 240 V
Solar charging time
Hours of good sun to charge from empty, assuming panels deliver 75% of their rating and one array per 200 W solar input.
| Panels | Power in | Hours of sun |
|---|---|---|
| 100 W of panels | 75 W | 14 hours |
| 200 W of panels | 150 W | 7.1 hours |
| 400 W of panels (split across inputs) | 300 W | 3.6 hours |
Check panel voltage and wiring with the solar charging calculator.
Full specifications
| Battery capacity | 1,070 Wh |
|---|---|
| Amp-hours at 12 V (converted) How we convert | 89.2 Ah (83.6 Ah at 12.8 V) |
| Battery chemistry LFP vs NMC | LiFePO4 (LFP) |
| Continuous AC output | 1,500 W |
| Surge (peak) output | 3,000 W |
| Boost mode | None listed |
| AC voltage | 120V |
| AC outlets | 3 |
| USB-C ports | 2 (up to 100 W) |
| USB-A ports | 1 |
| 12 V car outlet | Yes |
| Max solar input | 400 W (200 W per input) |
| Solar voltage range | 16–60 V |
| Solar max current | 10.5 A |
| Max AC charging power | 1,000 W |
| AC charging time (maker claim) | 0–100% in 1 hr (Emergency Super Charge via app); 1.58 hr standard |
| Expandable | No |
| UPS / EPS switchover What this means | 20 ms |
| Cycle life What this means | 4,000 cycles (to 70%) |
| Weight | 23.8 lb |
| Warranty | 5 years |
Notes: Cycles to 70%. 2×8mm DC inputs: 200W/10.5A each, 400W total (12–16V band ⎓8A for car). FAQ: AC input 1000W±50W, ~1.7 hr charge. Warranty 3+2 yrs.
Specs from Jackery's published documents, as of September 2026. Found an error? Tell us.
Sources
Similar power stations
- Explorer 1000 v2 vs Anker SOLIX C1000
- Explorer 1000 v2 vs EcoFlow DELTA 3
- Explorer 1000 v2 vs EcoFlow DELTA 3 Plus
- Explorer 1000 v2 vs BLUETTI Elite 100 V2
- Explorer 1000 v2 vs Anker SOLIX C1000 Gen 2
- Explorer 1000 v2 vs DJI Power 1000