BLUETTI Elite 300: Runtime & Specs
By Hicham M. · Specs from BLUETTI's published documents, as of September 2026 · How we calculate
The BLUETTI Elite 300 is a 3,014 Wh LiFePO4 power station with 2,400 W of continuous AC output and a 4,800 W surge rating. It runs a typical full-size fridge for about 44 hours.
We may earn a commission if you buy through these links. It never changes our numbers, and every model in our database is included whether or not it pays us. Learn more.
Simulated runtimes (not measured)
Nobody tested this unit for this page. These figures come from a computer simulation of the Elite 300, and they are estimates. The plain runtime table below divides energy by average draw at 85% efficiency. The simulation also charges the battery for the power the inverter burns just by being switched on, which is why small loads come out shorter. Where we have measured a unit, the measurement is shown separately and labeled as measured.
| Device | Spec-sheet math | Simulated, typical | Likely range | Simulated at 0 °C |
|---|---|---|---|---|
| Wi-Fi router + modem | 7.1 days | 3 days | 2.5 days to 3.8 days | 2.5 days |
| CPAP (no humidifier) | 3.6 days | 2.1 days | 45 hours to 2.5 days | 43 hours |
| Starlink Standard | 28 hours | 24 hours | 22 hours to 26 hours | 20 hours |
| Refrigerator (full-size, ENERGY STAR) | 44 hours | 33 hours | 30 hours to 37 hours | 29 hours |
Nonstop runtime from full to battery cutoff. Likely range = middle 80% of 200 simulated runs with the uncertain inputs varied. The inverter idle draw is assumed, not published: we assumed about 22 W for this model, varied from 13 to 34 W. If the real figure is lower, real runtimes land closer to the spec-sheet column.
How this was simulated
- The battery is stepped down every 2 minutes until it reaches cutoff, for 200 runs per device. Results are seeded, so the page shows the same numbers on every build.
- Battery draw = load + inverter idle draw + 4–8% of the load + a loss that rises with load squared (4% at full output).
- Usable capacity = 92–98% of rated Wh, for protection cutoff and aging.
- At 0 °C, 80–90% of that capacity is assumed available.
- Fridges cycle on and off every 30–50 minutes at the share of the time set by their average draw. The inverter idle draw continues while the compressor is off.
- Devices that exceed this model's output or surge rating are left out. Loads are US 120 V devices.
These ranges are assumptions about a typical unit. They are not manufacturer figures for the BLUETTI Elite 300. How we calculate · How we use AI
How long will the Elite 300 run your appliances?
Nonstop runtime for one device at a time, using typical US wattages and 85% inverter efficiency. Devices marked ✕ can't run on this model.
| Device | Avg draw | Runtime | Bar |
|---|---|---|---|
| LED light bulb | 9 W | 11.9 days | |
| Phone charging | 10 W | 11.3 days | |
| Wi-Fi router + modem | 15 W | 7.1 days | |
| Laptop | 50 W | 2.1 days | |
| CPAP (no humidifier) | 30 W | 3.6 days | |
| CPAP with heated humidifier | 60 W | 43 hours | |
| Starlink Standard | 90 W | 28 hours | |
| TV | 100 W | 26 hours | |
| Mini fridge | 29 W | 3.7 days | |
| Refrigerator | 58 W | 44 hours | |
| Chest freezer | 29 W | 3.7 days | |
| Sump pump (1/3 HP) | 160 W | 16 hours | |
| Sump pump (1/2 HP) | 210 W | 12 hours | |
| Window AC | 225 W | 11 hours | |
| Drip coffee maker | 1,000 W | 2.6 hours | |
| Microwave | 1,500 W | 1.7 hours | |
| Space heater | 750 W | 3.4 hours | |
| Well pump | 33 W | Needs 240 V |
Fridges, freezers, pumps and AC units cycle on and off, so we use their average draw. Want a mix of devices on a schedule? Use the runtime calculator.
What the Elite 300 can't power
- Well pump (1/2 HP submersible): needs 240 V
Solar charging time
Hours of good sun to charge from empty, assuming panels deliver 75% of their rating.
| Panels | Power in | Hours of sun |
|---|---|---|
| 100 W of panels | 75 W | 40 hours |
| 200 W of panels | 150 W | 20 hours |
| 400 W of panels | 300 W | 10 hours |
| 1,200 W of panels | 900 W | 3.3 hours |
Check panel voltage and wiring with the solar charging calculator.
Full specifications
| Battery capacity | 3,014 Wh |
|---|---|
| Amp-hours at 12 V (converted) How we convert | 251 Ah (236 Ah at 12.8 V) |
| Battery chemistry LFP vs NMC | LiFePO4 (LFP) |
| Continuous AC output | 2,400 W |
| Surge (peak) output | 4,800 W |
| Power Lifting (heating devices) | 4,800 W |
| AC voltage | 120V |
| AC outlets | — |
| USB-C ports | 2 (up to 140 W) |
| USB-A ports | 2 |
| 12 V car outlet | Yes |
| Max solar input | 1,200 W |
| Solar voltage range | 12–60 V |
| Solar max current | 22 A |
| Max AC charging power | 1,800 W |
| AC charging time (maker claim) | 0–80% in 95 min (1,800W Turbo) |
| Expandable | No |
| UPS / EPS switchover What this means | 10 ms |
| Cycle life What this means | 6,000 cycles (to 80%) |
| Weight | 58 lb |
| Warranty | 5 years |
Notes: AC outlet count not in text; BLUETTI PR says 11 outlets total incl. TT-30R. Surge from BLUETTI PR (page/manual call 4,800W 'lifting'). Also 12V/30A DC port. Unveiled CES 2026.
Specs from BLUETTI's published documents, as of September 2026. Found an error? Tell us.
Sources
Similar power stations
- Elite 300 vs Anker SOLIX F3000
- Elite 300 vs BLUETTI Apex 300
- Elite 300 vs Anker SOLIX F3800
- Elite 300 vs Anker SOLIX F3800 Plus
- Elite 300 vs BLUETTI Elite 200 V2
- Elite 300 vs EcoFlow DELTA 3 Max