BLUETTI AC200P: Runtime & Specs

By Hicham M. · Specs from BLUETTI's published documents, as of September 2026 · How we calculate

The BLUETTI AC200P is a 2,000 Wh LiFePO4 power station with 2,000 W of continuous AC output and a 4,800 W surge rating. It runs a typical full-size fridge for about 29 hours. It has been replaced or discontinued, but many are still in use.

Capacity2,000 WhLiFePO4

Output2,000 W4,800 W surge

Solar input700 W35–150 V

Weight60.6 lbexpands to 5,072 Wh

Check price on Amazon View at BLUETTI Calculate runtime for your devices

We may earn a commission if you buy through these links. It never changes our numbers, and every model in our database is included whether or not it pays us. Learn more.

Our notes

The AC200P's solar input starts at 35 V. A single 12 V-class panel won't charge it, so you'd wire two or more in series, or use one larger panel rated above 35 V, up to 150 V and 700 W. The higher voltage also means less loss over a long cable run.

The rest is a solid 2,000 Wh LiFePO4 unit with a 2,000 W inverter and 4,800 W surge, enough for a fridge (about 29 hours), a 1/2 HP sump pump (about 8 hours) or a microwave. Wall charging is slow, about 4.5 to 5 hours with the 500 W adapter, and there's no UPS mode. It takes one B230 or B300 battery, up to 5,072 Wh.

BLUETTI's AC200L is the closest current model: 2,048 Wh and 2,400 W, solar from 12 V instead of 35 V, wall charging at up to 2,400 W, a 20 ms UPS and expansion to 8,192 Wh, at almost the same weight (62.4 lb against 60.6 lb).

Simulated runtimes (not measured)

Nobody tested this unit for this page. These figures come from a computer simulation of the AC200P, and they are estimates. The plain runtime table below divides energy by average draw at 85% efficiency. The simulation also charges the battery for the power the inverter burns just by being switched on, which is why small loads come out shorter. Where we have measured a unit, the measurement is shown separately and labeled as measured.

Simulated runtimes for the BLUETTI AC200P
Device	Spec-sheet math	Simulated, typical	Likely range	Simulated at 0 °C
Wi-Fi router + modem	4.7 days	2.1 days	43 hours to 2.7 days	43 hours
CPAP (no humidifier)	2.4 days	37 hours	32 hours to 41 hours	31 hours
Starlink Standard	19 hours	16 hours	15 hours to 17 hours	14 hours
Refrigerator (full-size, ENERGY STAR)	29 hours	23 hours	21 hours to 25 hours	19 hours

Nonstop runtime from full to battery cutoff. Likely range = middle 80% of 200 simulated runs with the uncertain inputs varied. The inverter idle draw is assumed, not published: we assumed about 20 W for this model, varied from 12 to 30 W. If the real figure is lower, real runtimes land closer to the spec-sheet column.

How this was simulated

The battery is stepped down every 2 minutes until it reaches cutoff, for 200 runs per device. Results are seeded, so the page shows the same numbers on every build.
Battery draw = load + inverter idle draw + 4–8% of the load + a loss that rises with load squared (4% at full output).
Usable capacity = 92–98% of rated Wh, for protection cutoff and aging.
At 0 °C, 80–90% of that capacity is assumed available.
Fridges cycle on and off every 30–50 minutes at the share of the time set by their average draw. The inverter idle draw continues while the compressor is off.
Devices that exceed this model's output or surge rating are left out. Loads are US 120 V devices.

These ranges are assumptions about a typical unit. They are not manufacturer figures for the BLUETTI AC200P. How we calculate · How we use AI

How long will the AC200P run your appliances?

Nonstop runtime for one device at a time, using typical US wattages and 85% inverter efficiency. Devices marked ✕ can't run on this model.

Estimated runtime by appliance for the BLUETTI AC200P
Device	Avg draw	Runtime
LED light bulb	9 W	7.9 days
Phone charging	10 W	7.5 days
Wi-Fi router + modem	15 W	4.7 days
Laptop	50 W	34 hours
CPAP (no humidifier)	30 W	2.4 days
CPAP with heated humidifier	60 W	28 hours
Starlink Standard	90 W	19 hours
TV	100 W	17 hours
Mini fridge	29 W	2.4 days
Refrigerator	58 W	29 hours
Chest freezer	29 W	2.4 days
Sump pump (1/3 HP)	160 W	11 hours
Sump pump (1/2 HP)	210 W	8.1 hours
Window AC	225 W	7.6 hours
Drip coffee maker	1,000 W	1.7 hours
Microwave	1,500 W	1.1 hours
Space heater	750 W	2.3 hours
Well pump	33 W	Needs 240 V

Fridges, freezers, pumps and AC units cycle on and off, so we use their average draw. Want a mix of devices on a schedule? Use the runtime calculator.

What the AC200P can't power

Well pump (1/2 HP submersible): needs 240 V

Solar charging time

Hours of good sun to charge from empty, assuming panels deliver 75% of their rating.

Panels	Power in	Hours of sun
100 W of panels	75 W	27 hours
200 W of panels	150 W	13 hours
400 W of panels	300 W	6.7 hours
700 W of panels	525 W	3.8 hours

Check panel voltage and wiring with the solar charging calculator.

Full specifications

Battery capacity	2,000 Wh
Amp-hours at 12 V (converted) How we convert	167 Ah (156 Ah at 12.8 V)
Battery chemistry LFP vs NMC	LiFePO4 (LFP)
Continuous AC output	2,000 W
Surge (peak) output	4,800 W
Boost mode	None listed
AC voltage	120V
AC outlets	6
USB-C ports	1 (up to 60 W)
USB-A ports	4
12 V car outlet	Yes
Max solar input	700 W
Solar voltage range	35–150 V
Solar max current	12 A
Max AC charging power	500 W
AC charging time (maker claim)	≈4.5–5 h (AC adapter)
Expandable	Yes, up to 5,072 Wh
UPS / EPS switchover What this means	Not listed
Cycle life What this means	3,500 cycles (to 80%)
Weight	60.6 lb
Warranty	4 years

Notes: Sold out on US site. Takes 1x B230 or B300 via P090D-XT90 cable (5,072Wh kit with B300). 12V/25A RV outlet. No UPS mode. Warranty 24+24 months. Manual PDF not text-readable.

Specs from BLUETTI's published documents, as of September 2026. Found an error? Tell us.

Sources

Similar power stations

Questions

How long will the BLUETTI AC200P run a refrigerator?

About 29 hours for a typical ENERGY STAR full-size fridge averaging 58 W, assuming 85% inverter efficiency. Older or larger fridges use more. Try your own numbers.

Can the BLUETTI AC200P run a microwave?

Yes. A typical 1,000 W microwave pulls about 1,500 W from the outlet, within its 2,000 W continuous output. A full battery gives about 1.1 hours of cooking.

How many amp-hours is the BLUETTI AC200P?

The BLUETTI AC200P works out to about 167 Ah at 12 V, or 156 Ah at 12.8 V, the nominal voltage of a 12 V LiFePO4 battery. Both are our conversion of BLUETTI's 2,000 Wh rating: amp-hours = watt-hours ÷ volts. The battery inside may run at a different voltage, so an amp-hour figure in a manual or on a product listing can look very different for the same energy. For scale, a 12 V 100 Ah LiFePO4 battery holds 1,280 Wh, so this model holds about as much as 1.6 of them. How we convert amp-hours.

How long does the BLUETTI AC200P take to charge?

BLUETTI's published charging claim: “≈4.5–5 h (AC adapter)”. Max AC charging power is 500 W. With solar, it accepts up to 700 W. With 700 W of panels that's roughly 3.8 hours of good sun from empty.

Is the BLUETTI AC200P expandable?

Yes, up to 5,072 Wh with BLUETTI's extra batteries.